6/15/2023 0 Comments Zoiper pjsip![]() Firstly the on pbx behind the IP change the pjsip channel collapses completely, no trunks are available and interestingly even pjsip extensions become unavailable and only recover after restarting the asterisk service. However on pjsip this has proved a nightmare. With chan_sip a change of IP at any location can quickly be recovered from with all trunks, service providers and internal links back up and working in less than five minutes without any need for user intervention. My biggest problem has been dealing with dynamic IP addresses. My problems with these trunks remain as I haven’t had time to investigate further.Ī trunk between two Freepbx 13 systems is working fine. I have another trunk with orbtalk (UK Supplier) that requires an out bound proxy, that also registers fine with pjsip, calls can be made in and out but I only get audio in, no outbound audio on external calls. I have a sipgate (UK Supplier) account setup with pjsip, it registers fine, will receive calls fine but refuses to let me dial out. You need to compile separately for each architecture by setting ARCH environment variable to the desired architecture before running /openssl/openssl_arm) and add them to the project.I have been experimenting with pjsip on both freepbx 12 and 13 with various success and failure.įrom the point of extensions there seems to be no difference, chan_sip and pjsip have worked well for me, the benefit of multiple end points on pjsip is useful.Īs regards trunks I have had a lot more problems. Supporting multiple architectures (armv6, armv7, armv7s, arm64, and so on) other customizations are similar to what is explained in Building with GNU page.For ipjsua, select Project-Edit Project Settings-Base SDK and Targets-ipjsua-Get Info-Base SDK to change the SDK version. You may change this by setting IPHONESDK environment variable to the desired SDK path. the latest iPhone SDK version will be selected by default.configure script with settings suitable for iPhone target. configure-iphone is a wrapper that calls the standard. See PJSUA CLI Manual for commands available. Telnet to this address to operate the application. You will see telnet instructions on the device's screen. If you enable video and use libyuv/libopenh264, add the libraries into the application. Open ipjsua.xcodeproj using Xcode in pjproject/pjsip-apps/src/pjsua/ios. This will activate iPhone specific settings in the config_site_sample.h. Set your config_site.h to the following:.Get the source code, if you haven't already.Command Line Tools for Xcode: download from Apple Developer Downloads then install.it has a native CoreAudio based audio device, which supports the following features:. ![]() Unable to accept incoming call in background mode (iOS 8 or before).Other Problems (problem specific to a particular iOS version/device).SIP transport keepalive while in background.Audio lost or other issues with interruption (by a phone call or an alarm), headset plug/unplug, or Bluetooth input.Crash after calling PJLIB APIs using Grand Central Dispatch (GCD).CallKit integration and audio session (AVAudioSession) management (iOS 10).PushKit guide, to accept calls in the background after kCFStreamNetworkServiceTypeVoIP is deprecated (iOS 16/iOS 10/iOS 9). ![]()
0 Comments
Leave a Reply. |